StarTech.com 410VDSLEXT2 Instruction Manual download pdf (Page 8)

Instruction Manual

Installation

Hardware Installation

Transmitter Unit

1. Connect the provided power adapter from an AC electrical outlet to the DC Input on

the Transmitter Unit. The “PWR” LED should light up solid.

2. Set all four of the DIP switches to the upward (OFF) position. This places the unit in

CO mode.

3. Connect an RJ45 Ethernet cable to the RJ45 LAN Port on the Transmitter Unit.

4. Connect the other end of the Ethernet cable into your Ethernet network device (eg:

switch, Ethernet modem).

5. Connect an RJ11 phone cable into the VDSL Port on the Transmitter Unit.

6. Connect the opposite end of the RJ11 cable to the DSL Port on the Receiver Unit (or

to your buildings RJ11 phone line infrastructure, depending on your setup).

Optional: Congure DIP switches 2 through 4 as necessary (see “DIP Switch Settings”

section below).

Receiver Unit

1. Place the Receiver Unit at the end-point location.

2. Connect the provided power adapter from an AC electrical outlet to the DC Input on

the Receiver Unit. The “PWR” and “SYS” LED should light up solid.

3. If not previously completed, connect the RJ11 cable that was inserted into the RJ11

VDSL Port on the Transmitter Unit directly to the DSL Port on the Receiver Unit (or

from your buildings existing RJ11 analog telephone wiring, depending on the setup

from step 6 above.

4. If the Transmitter and Receiver Units are able to successfully communicate with each

other, the “LINK” LED should light up solid.

5. Connect each computer or Ethernet networking device to an available RJ45 Port

on the Receiver Unit. The respective “LAN” LED on each individual RJ45 Port should

light up to indicate a successful physical connection.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

StarTech.com 410VDSLEXT2 Instruction Manual Page 8