StarTech.com USBDUP12 Instruction Manual download pdf (Page 16)

Instruction Manual

7.3 Button Beep

Turn audio feedback ON/OFF. ON by default.

7.4 Asyn Hold time

Set the time to cancel an Asynchronous copy when you’ve temporarily nished

copying and all of the Flash drive devices have been removed, but the copy job has not

been manually cancelled. This is to prevent mistakenly overwriting your source drive

when you’d like to start a new source copy but the previous Asynchronous copy job

has not yet been cancelled.

The default is 30 seconds. When the system no longer detects any Flash drive for 30

seconds, the system will prompt you to either exit or keep the current copy job.

7.5 Target Tolerance

Set the tolerance of the capacity gap between the source and destination ports in %.

There are three modes, with the default being ‘no limit’, as follows:

a. Allow Tolerance: Users can set the high and low limit (%) of capacity dierence

between the source and destination drive separately.

b. No Limit: Users can disable the capacity limit between the source and destination

drive. If the data on the source drive is larger than the capacity of the destination

drive, this will lead to an incomplete/failed duplication.

c. 100% same: Users can set the capacity of the destination drives to be the exact

same as the source drive. If the sizes do not match, the duplication will not start.

7.6 Asynchronous Mode

Choose to disable or enable Asynchronous copy mode. If enabled and the data

on the source is smaller than the system’s buer memory, it will automatically use

asynchronous when copying. If disabled, the system will copy in synchronous mode.

This mode is enabled by default.

7.7 Check before Copy

Choose to enable or disable the system checking the Flash drive before starting a copy.

By default, the drive is not checked before copying.

7.8 Power o time between Copy + Compare

When performing the Copy + Compare function, set the wait time (in seconds) after a

Copy has completed, and before the Compare starts. The default is 3 seconds.

7.9 Language

Change the system language between English and Japanese

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

StarTech.com USBDUP12 Instruction Manual Page 16