StarTech.com USBDUP12 Instruction Manual download pdf (Page 10)

Instruction Manual

NOTE:

a. When the copy is in progress, the green LED will ash for each Flash drive that is

connected. When the copy has nished, the green LED will stop ashing and remain

illuminated. If an error occurs, the red LED will illuminate.

b. Do NOT remove the Flash drives while the system is copying (green LED is ashing).

You can cancel a duplication by pressing ESC.

c. It is recommended that the source and destination are the same size. Copying to or

from a larger Flash drive may cause an error and the copy will fail.

d. If copying a Flash drive with NTFS or Linux le formats, the destination capacity

MUST BE equal or larger than the source’s capacity.

1.2 Asynchronous Copy

NOTE: This mode is enabled by default. The source’s content size must be smaller

than the system’s buer memory, otherwise the system will automatically duplicate in

Synchronous mode.

To enable Asynchronous mode, go to function “7.6 Asynchronous”, and select “Enable”.

Operating Process

1. Plug in the source Flash drive, and press OK. The system will start to read the

source’s content into the system’s buer. Once completed, it will immediately start

to copy once a destination Flash drive has been plugged in.

2. Once the copy has completed, the green LED will stop blinking. The destination

Flash drive can be removed and a new Flash drive inserted, then the copy will

automatically start again. The LCD display will show the accumulated quantity of the

successful/failed duplications and the drive that is still copying.

Pass: 2

Fail: 0

The quantity of ash media in process

Quantity of copy pass and copy fail

COPY

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

StarTech.com USBDUP12 Instruction Manual Page 10