StarTech.com USBDUP12 Instruction Manual download pdf (Page 15)

Instruction Manual

6.5 Full Erase

Erase the Flash drive’s content and format.

6.6 DoD Erase

This function complies with the U.S.A Department of Defense (DoD 5220) standard to

fully erase the Flash drive three times to guarantee the data has been deleted.

NOTE: The source drive will not be formatted.

6.7 System Update

Update the system’s rmware version. Save the rmware update onto your Flash drive.

Make sure the rmware update le is un-zipped and not in a folder.

To start, press OK on “6.7 System Update” and it will automatically start updating. When

completed, turn o the system for 5 seconds and then turn back on. The rmware

update is now complete.

6.8 Calc. Checksum

Calculate the Checksum number of the Flash drive that’s plugged into the source port.

The Checksum area that is calculated will be based on the copy area that’s been set.

7. Setup

7.1 Start-up Menu

Select which function is displayed when the system is rst turned on.

7.2 Copy Area

7.2.1 System and Files

This is also called ‘quick copy’ mode. The system will automatically analyze the source

drive’s le format. If the le format is recognized (FAT16/32, NTFS, Linux (ext2, ext3,

ext4)), only the data will be copied. Otherwise, if the le format is not recognized, the

system will copy the entire storage capacity of the Flash drive, including empty space.

‘System and Files’ is enabled by default.

7.2.2 Whole Media

Set the system to copy the entire Flash drive’s content, including empty space and

le format.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

StarTech.com USBDUP12 Instruction Manual Page 15