StarTech.com HSB2535SATBK Instruction Manual download pdf (Page 6)

Instruction Manual

Hardware Installation

1. Ensure your computer system is powered down, and the power cable has been

disconnected from the Power Supply.

2. Open your computer case (refer to the computer user manual for details), and place

the 2.5/3.5in SATA HDD Backplane into an available 5.25” slot, lining up the side

installation holes on the HSB2535SATBK (pictured below), with installation holes on

the 5.25” slot inside the computer.

3. Hold the HSB2535SATBK into place, and x 4 of the included screws through

the installation holes on the 5.25” slot, into the side installation holes on the

HSB2535SATBK.

4. Connect one of the included “18in SATA cables” from an available SATA host port on

your motherboard to the “2.5” Drive SATA port” on the back of the HSB2535SATBK.

5. Connect one of the included “18in SATA cables” from an available SATA host port on

your motherboard to the “3.5” Drive SATA port” on the back of the HSB2535SATBK.

6. Connect a Molex LP4 Power header from your power supply to the “LP4 Power

Connector” on the back of the HSB2535SATBK. If you do not have an LP4 connector

available, use the included “Molex LP4 to SATA Power Adapter Cable” with an

available SATA Power Header from your power supply.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

StarTech.com HSB2535SATBK Instruction Manual Page 6