StarTech.com UNIDOCKU33 Instruction Manual download pdf (Page 7)

Instruction Manual

IDE Drive Installation

1. Connect the included 40-pin IDE ribbon cable to the IDE connector on the rear of

the dock. If using a 2.5in IDE hard drive, connect the 40 to 44-pin IDE cable to the

rear of the dock.

2. Connect the included LP4 Molex power cable into the LP4 connector on the rear

of the dock. If using the 40 to 44-pin cable, connect the built-in LP4 connector to

the connector on the rear of the dock.

3. Connect the IDE hard drive to the ribbon cable and LP4 Molex connector (3.5in

only). Make sure all of the cables are securely connected.

4. Insert the IDE hard drive into the top-loading drive bay (closest to rear connectors).

5. Press the IDE Hard Drive power button.

Note: If your computer fails to automatically recognize your drive it is likely your drive

has not been initialized or formatted correctly. (See Drive Initialization in Software

operation for further instructions.)

SATA/IDE Drive Removal

WARNING:

Ensure your hard drive(s) has been disconnected from your computer operating

system prior to attempting drive removal. Failure to properly disconnect your drive

may result in lost data or drive damage. (See Disconnecting the Hard Drive in Docking

Station Operation for further instructions.)

1. Turn o your drive by pressing the corresponding power button.

2. (Only required for IDE drives) If you have a 3.5in IDE drive, disconnect the 40pin IDE cable

and the LP4 power cable (3.5in drive) from both your hard drive and the docking station.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

StarTech.com UNIDOCKU33 Instruction Manual Page 7