StarTech.com USB2HDCAP Instruction Manual download pdf (Page 6)

Instruction Manual

Hardware Installation

1. Connect the type B connector on the included USB cable to the USB2HDCAP device

2. Connect the type A connector on the included USB cable to an available USB 2.0

port on your computer system.

NOTE: After you connect the physical hardware to the computer it is likely that you

may receive prompts for installation. Please close these specic prompts as these

steps will be performed during software installation.

3. Connect your video source (DVD, DVR, VCR, Etc.) to the HDMI, Composite or S-Video

input on the USB2HDCAP depending on the video source.

Note: If intending to capture a composite video signal, connect the composite cable

to the Component Y (Green) input.

Software Installation

After Hardware Installation the “Found New Hardware Wizard” will open, click “Cancel”

to close the window.

1. Download the latest drivers from the StarTech.com website (recommended), or

insert the included Driver and Software Disk into your DVD-ROM drive.

2. Locate the Setup(.exe) application. This le will be located in Windows directory

in the downloaded folder, or if using the included Driver and Software DVD the

installation will begin automatically.

3. The Driver installation program will begin. If a Windows Security dialog window

appears, click the “Run” or “Install this driver software anyway” option to proceed.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

StarTech.com USB2HDCAP Instruction Manual Page 6