StarTech.com SDOCK2U33RE Instruction Manual download pdf (Page 7)

Instruction Manual

Drive Installation

1. Carefully align and insert the 2.5” or 3.5” SATA drive(s) you wish to dock in the

desired hard drive slot on the docking station, such that the SATA power and data

connectors on the drive are properly aligned with the corresponding connectors

inside the hard drive slot.

Note: If connecting drives for duplication, the drive containing the DATA you intend

to be copied, should be placed in the Source bay (Hard drive #2 slot). While the drive

you intend to have the DATA copied to should be placed in the destination bay

(Hard drive #1 slot).

2. Press the power button so the docking station is turned on.

Drive Removal

WARNING! Ensure your hard drive(s) has been disconnected from your computer

operating system prior to attempting drive removal. Failure to properly disconnect

your drive may result in lost data or drive damage. (See Disconnecting the Hard Drive

in Docking Station Operation for further instructions.)

1. Turn o the docking station by pressing the power button.

2. Press the eject button that corresponds with the drive you wish to remove.

3. Carefully grasp the ejected drive and lift it upwards until the bottom of the drive

has completely risen above the hard drive slot.

4. Safely and carefully store your drive in a secure location. (See your hard drive

manual for proper storage instructions.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

StarTech.com SDOCK2U33RE Instruction Manual Page 7